Available only online and shipped within 24/72h
The product is available in our remote warehouses but not physically in-store. Upon order, it will be processed within approximately 24 hours, with an estimated delivery time of 3 to 5 working days.
Ask an expert
We are musicians and at your service, contact us!
info@yourmusiconline.it
RME PRO LINE LNI-2 DC Filter and Stabilizer
Low Noise Isolating DC Filter, 12 Volt 2 Ampere,
DC Input and Output
RME presents the LNI-2 DC, a spectacular active DC filter, compact and portable, milled from a solid block of aluminum. The LNI-2 DC provides isolation, regulation and filtering of output signals from any 12 volt DC power source, enabling a remarkable improvement in DC voltage stability while providing an ultra-clean 12V power source. This results in an enhanced audio signal and sound quality avoiding humming, buzzing and other noises that can be caused by power supplies or dirty mains power.
The LNI-2 DC is based on two key features: galvanic isolation and RME's exclusive μFilter. Galvanic isolation is an advanced technique to prevent any noise, from hum over high frequency noise to leakage currents from reaching the filtered DC output. Without galvanic isolation parts of these noises will creep over into the filtered signal. Galvanic isolation makes it possible to not only filter the positive DC path, but also separates ground (aka minus) between input and output.
LNI-2 DC
DC Input
Input voltage range: 9 – 18 V DC
Polarity: Center +, Outside -
Connector: 2.1x5.5mm, lockable or normal
Power consumption idle: 0.7 Watt
Power consumption typical, 12V input, 2 A load: 31 Watts
DC Output μFilter
Output voltage: 12.0 V
Continuous output current: 2.0 A
Continuous output power: 24 Watt
Maximum output current: 3.0 A
Noise @ 0 - 3 A, AES17: < 2 μV, < 1 μV A-weighted
Noise @ 0 - 3 A, 100 kHz bandwidth: <3 μV, < 2 μV A-weighted
Output impedance including cable: 0.012 Ohm
Load Regulation (0/1/2 A): 0.20 %
Overload protection: > 3.0 A
Overheating protection: > 80 °C (176 °F)
Undervoltage detection: < 9.0 V
Short circuit current (LED red): <0.1 A
Filter (decoupling) efficiency, 10 Hz – 1 kHz: >110 dB
Filter (decoupling) efficiency, 1 kHz - 200 kHz: >70 dB
General
Dimensions (WxHxD): 80 x 30 x 123 mm, 3.15“ x 1.18“ x 4.84“
Weight: 605 g (1.33 lbs)
Temperature range: +5 °C up to +40° Celsius (41 °F up to 104 °F)
Relative humidity: < 75%, not condensing
Package Contents
LNI-2 DC
DC Sensor connection cable with lockable DC plug 2.1x5.5 mm, 1 m
DC Sensor connection cable with DC plug 2.1x5.5 mm, 1 m
Manual
No downloadable documents available. For more information, contact us at info@yourmusiconline.it
Pro Audio Accessories
Available only online and shipped within 24/72h
Free shipping
Sound Cards
Available in store and online
Free shipping
Sound Cards
Available only online and shipped within 24/72h
Free shipping
Studio Equipment
Available in store and online
Free shipping
Studio Equipment
Not available
Free shipping
Microphones
Available in store and online
There are no reviews yet. Register and leave yours!
